Note: Soldering Steel Connectors to a Brass Block

Objective:

Heat an assembly of small, gold-plated steel connectors to a brass block. 

End Product:

Brass block

Equipment:

Ambrell 1 kW induction heating system equipped with a remote workhead.
An induction heating coil designed and developed specifically for this application

Materials:

Approx. 1/8” (3.2mm) diameter gold-plated steel connectors
1”(25.4mm) square x 1/4” thick brass block 

Temperature:

600°F (315.6ºC)

Frequency:

240 kHz

Testing:

A two-turn helical coil is used to provide uniform heat to parts assembly. Solder paste and flux are applied to the joint area and power is applied for 20 seconds to solder the parts. Proper fixturing is needed to hold the parts in position.

Benefits:

  • Rapid, localized heating to specific regions of part

  • Neat and clean joints

  • Flameless processing 

Soldering Steel Connectors to a Brass Block

Visit our Applications Lab to learn more about free applications testing.
1655 Lyell Ave, Rochester, NY 14606 USA | Tel: +1 585 889 9000