Note: Soldering Solar Flex Circuits
Objective:
Heat multiple joints on solar flex circuit strips to 500°F (260ºC) within ten seconds for a soldering application.
End Product:
flex circuits
Equipment:
Ambrell 1 kW induction heating system equipped with a remote workhead with one 1.2 µF capacitor An induction heating coil designed and developed specifically for this application.
Materials:
Flexible solar panel, Solder Plus Paste 63NC-A, 0.0625” (1.59mm) thick Teflon sheets
Temperature:
500 °F (260ºC)
Frequency:
278 kHz
Testing:
A specially-designed induction coil is used to provide even heat in the area where the wires on the solar circuits overlap. A very light coat of solder paste is applied to the circuit connections and a small amount of pressure is applied to the Teflon sheets to hold the circuits together. Power is applied for 10 seconds to flow the solder paste and bond the wires to the flex circuits
Benefits:
Induction heating provides:
-
Consistent and repeatable results
-
Non-contact clean heating
-
Flameless process

Visit our Applications Lab to learn more about free applications testing.
1655 Lyell Ave, Rochester, NY 14606 USA | Tel: +1 585 889 9000