Note: Reflowing the solder of an area on a circuit board
Objective:
To heat a solder joint to reflow the solder on a circuit board evenly
End Product:
printed circuit boards
Equipment:
Ambrell EASYHEAT™ 10 kW, 150-400 kHz induction heating power supply with a workhead and coil specifically designed for this application.
Materials:
Soldered contacts in two areas (2 x 2 mm) on a circuit board of diesel fuel tank components
Temperature:
482º F (250º C)
Frequency:
240 kHz
Testing:
A multiple-turn helical coil was designed for ease of loading and unloading. There were sensitive electrical components near the heating area that could not be heated, which was taken into account during process development.
An aluminum fixture is a large heat sink to the induction field. In order for solder alloy to wick and run the length of the overlap area, flux was applied to the solder location. In order to reach the desired temperature, the heat was applied for 2.5-3 seconds. Heating was very uniform without concern for overheating
Benefits:
Repeatability: Induction offers superior repeatability when compared to alternative soldering methods like heating irons.
Speed: Induction can offer superior speed when compared to a soldering iron.
Part Quality: Superior repeatability means a more consistent result and enhanced product quality.

Visit our Applications Lab to learn more about free applications testing.
1655 Lyell Ave, Rochester, NY 14606 USA | Tel: +1 585 889 9000