Wählen Sie aus unseren kostenlosen Anwendungshinweisen

Curing Oil Filters for Agricultural Equipment

To heat steel parts for a curing application; the end-product was an oil filter for agricultural equipment.

Curing coatings; steel tube, aluminum block

The client's oven had a heating time of 20 minutes, so the time savings from a 90-second cycle are considerable. Additionally, induction is a repeatable process, unlike an oven and the induction system takes up less floor space than an oven.

Curing plastisol adhesive, ends of filter assembly

Induction heating provides improved distribution of heat, much faster cure time than heat plates previously used, much faster production rate and hands-free heating that involves no operator skill for manufacturing

Curing a coating; both sides aluminum piston

A three-turn channel coil 19 (48.26cm) long is used to anneal 4 pistons running though the coil with a distance of 6 (15.24cm) between centers.

Curing epoxy on aluminum copier roller assembly

A four-turn helical pancake coil is used to heat the end of the copier roller assembly. The assembly is heated 90 seconds to cure the adhesive.

Curing plastisol adhesive on an aluminum filter assembly

A four turn helical coil is used to cure the plastisol adhesive. One filter end cap is filled with adhesive, attached to the filter and heated 90 seconds to cure the adhesive.

Curing ink on aluminum bottle caps

A double channel coil is used for the ink drying application. Fifteen bottle caps are placed inside the coil and power is applied for 3 seconds to dry the ink.

Curing Aluminum Car Molding

Automotive manufacturers are constantly searching for cost-effective production technologies.

Curing Ceramic Fiber

A special steel tube and coil combination is used to build an induction heating oven to cure the fiber on a continuous basis. The ceramic fiber travels in an alumina tube inside a hot steel tube

Curing Speaker Cone Epoxy

Induction heating provides minimized coating defects, repeatable results and faster production times

Curing the Inside Liner of Baby Food Bottle Tops

A three turn oval pancake coil is used to cure the inside liner of a baby food bottle cap. The bottle cap travels through the coil at 25 per second to cure 500 caps per minute.

Bonding Rear View Mirror Brackets to Windshield Glass

A unique four-over-four double wound pancake coil is used for the bonding application.

Curing Adhesive on Steel Motor Shaft for Bonding

A complex two coil system, shield and stud systems used to provide proper axial alignments of the shaft & coil while allowing the fixture to be open for removal of the shaft.

Heating Aluminum Auto Trim for Adhesive Curing

To heat various sizes of aluminum auto trim to 500°F (260°C) at a rate of 30 ft. (9.1m) per minute for curing an adhesive.

Curing Measuring Tape Paint

The Ambrell 20kW output solid state induction power supply along with a unique 30 inch long multi turn helical coil was found to produce the following results.